IPX7 Immersion device

NOKI IPX7 Immersion Device Product Introduction

IPX7 water immersion device is divided into a stainless steel box and a transparent tempered glass box, or maybe PVC materials. The IPX7 immersion device is immersed in water for a short time under less pressure, simulating a shallow water pressure environment.

The main application areas of IPX7 immersion devices include electronic components, outdoor lamps, mobile phone casings, auto parts, etc.

IPX7 immersion device working principle

Put the sample into the device. According to the size of the sample, put the test object into the corresponding height. After 30 minutes of testing, observe whether there is water immersion inside the test object.

The lowest point of the enclosure where the height of the item is less than 850mm should be lower than 1 meter above the water surface.

The highest point of the enclosure whose height is greater than or equal to 850mm should be 0.15 meters below the water surface.

NOKI IPX7 immersion device standard parameters

Immersion device product structure

The device is made of SUS304 stainless steel, which is a sealed space. Guaranteed to be used for a long time without water leakage.

The glass device is made of plexiglass, which is fully transparent, which is convenient to observe the condition of the test object during the test.

The equipment is equipped with a castpr wheel, which is convenient to move, and it is convenient for the operator to save effort when pushing.

The hanging basket can be customized according to the sample size. Whether or not to use an electric hoist depends on whether your test requires it.

Immersion device application standard

GB/T 4208-2017 Protection class of enclosure (IP code)

GB/T 2421.1-2008 Environmental Testing of Electrical and Electronic Products - Overview and Guidelines

IEC 60529:2013. IDT

IEC 60068-1:1988. IDT

IEC 60050-195:1998 International Electrotechnical Terminology Part 195: Earthing and Protection against Electric Shock

IEC 60050(826):1982 International Electrotechnical Terminology Chapter 826: Electrical installations in buildings

IEC 60071-2:1996 Insulation coordination - Part 2: Guidelines for use

Noki equipment precautions

There are certain requirements for the surrounding environment of the equipment site, such as maintaining good ventilation, the need to install a ventilation fan, and the prohibited items for the equipment include flammable, explosive, and corrosive substances, and there should be no strong vibration or strong vibration around the equipment. The phenomenon of electromagnetic fields occurs and thus affects the tester. When the equipment is running, the water tank should be checked first to ensure that there is enough water. When the equipment is running, if there is an abnormal sound, it needs to be stopped immediately for inspection.

Immersion device maintenance method

1. The equipment will be exposed to the external environment for a long time, and the outer surface of the equipment will collect a lot of dust. In order to ensure that the equipment has an impact on the indoor beauty, cleanliness, and aging of equipment, it is necessary to clean the outer surface of the equipment once a week. clean.

2. Because the testing machine is exposed to the outside environment for a long time, a lot of dust will accumulate in the distribution board, meter, water circuit, etc. in the power distribution room. At this time, when the air becomes humid, it will cause equipment failure. Therefore, in order to ensure The equipment can operate stably for a long time. Please clean the power distribution room once a month.

Power supply

AC220V 50HZ Single-phase three-wire system, single-phase 220V